ROTADISK Pneumatic Actuator RD & RDF
Operating Manual – BA3002 EN
2 Safety Information
Page 26 of 79
2.7 Product Warranty Information
All improper uses of the ROTADISK Pneumatic Actuator can impair its function. This will lead
to the voiding of all product warranty rights!
Please note that the owner company is liable in the following cases:
▪
The ROTADISK Pneumatic Actuator is operated in a way that is not compliant with
this operating manual, especially with regard to the safety messages, handling
instructions and section 2.8 Intended Use.
▪
The ROTADISK Pneumatic Actuator is put into operation by personnel who are not
qualified for work on the ROTADISK Pneumatic Actuator.
▪
The ROTADISK Pneumatic Actuator is used with spare parts and/or accessories
from third suppliers which do not originate from Flowserve Flow Control GmbH.
▪
The ROTADISK Pneumatic Actuator is operated with unauthorised modifications.
2.8 Intended Use
The ROTADISK Pneumatic Actuator is intended to be used within the operating
parameters/operating limits for switching valves.
In order to avoid personal injury and/or material damage, make sure that the
operating parameters on the nameplate and the structural design of the
ROTADISK Pneumatic Actuator are suitable for the specific application.
See section 1.7 Nameplate: Identification of the ROTADISK Pneumatic
Actuator.
Observe all labels on the ROTADISK Pneumatic Actuator and keep in a legible
condition.
Replace damaged and/or illegible labels immediately if necessary.
ROTADISK Pneumatic Actuators are basically suitable for use in explosive areas (ex-zones 1
and 2). ROTADISK Pneumatic Actuators have no own potential ignition sources when used
as intended and are therefore not “devices” in the sense of article 1 of the directive
2014/34/EU (“ATEX Directive”).
To Next Page
Loading...
Need help?
General
