ROTADISK Pneumatic Actuator RD & RDF
Operating Manual – BA3002 EN
12 Transport
Page 71 of 79
12.2 Transporting the ROTADISK Pneumatic Actuator
The following prerequisites are satisfied:
The ROTADISK Pneumatic Actuator
▪
is not connected to and has been dismantled from the valve (e.g. ball valve).
▪
is free from dirt.
▪
is dry.
1. Protect the ROTADISK Pneumatic Actuator against damage with suitable
transport protection (e.g. packing blanket).
2. In the case of a heavy ROTADISK Pneumatic Actuator (≥ 15 kg), strap the sling
loops of a suitable lifting gear around the body of the ROTADISK Pneumatic
Actuator or fasten the slings to the lifting eyes (if available).
3. Make sure that the ROTADISK Pneumatic Actuator cannot turn when lifted.
4. Hang the sling loops in the load hook of a suitable lifting gear.
5. Transport the ROTADISK Pneumatic Actuator to the desired location and set it
down carefully.
6. Remove the slings from the ROTADISK Pneumatic Actuator.
✓ Transport of the ROTADISK Pneumatic Actuator is completed.
To Next Page
Loading...
Need help?
General
