ROTADISK Pneumatic Actuator RD & RDF
Operating Manual – BA3002 EN
2 Safety Information
Page 27 of 79
2.9 Misuse
Misuse (only reasonably foreseeable misuse) is identified in the following cases:
▪
The ROTADISK Pneumatic Actuator is not used for switching valves (e.g. ball valves)
▪
The ROTADISK Pneumatic Actuator is not operated within the operating parameters/limits
specified on the nameplate.
▪
Installation, commissioning, maintenance, repair and other work on the ROTADISK
Pneumatic Actuator are not carried out according to this operating manual.
▪
The ROTADISK Pneumatic Actuator is out into operation without observing the instructions
on the product.
▪
The ROTADISK Pneumatic Actuator is modified or used with spare parts that are not
provided by Flowserve Flow Control GmbH.
▪
The ROTADISK Pneumatic Actuator is out into operation without all acceptance test
criteria being successfully fulfilled.
▪
The ROTADISK Pneumatic Actuator is operated in a partially installed state.
If there are any doubts regarding the suitability of the ROTADISK Pneumatic Actuator
for the respective intended use, contact the Quick Response Center (QRC) of
Flowserve Flow Control GmbH and state the serial number or article number of the
ROTADISK Pneumatic Actuator that is specified on the nameplate.
If the application conditions change (for example, fluids, temperature or pressures),
contact the Quick Response Center (QRC) of Flowserve Flow Control GmbH for
support before putting the ROTADISK Pneumatic Actuator into operation.
To Next Page
Loading...
Need help?
General
