1672/1673 FC/1674 FC
Users Manual
18
Display
The Display menu has the options for:
Display orientation
Function screen type
Display brightness
To s e t :
1. Open the Device Settings Menu:
2. Highlight and select System Settings.
3. Highlight and select Display.
4. Highlight the option and tap on the parameter or push the center of the rotary dial to make
a change.
5. Tap
2 to exit the menu.
Beeper
The Tester has an internal beeper that sounds a tone after each completed measurement. The
beeper has two tones to indicate a positive or negative result. The positive tone is confirmation
of a successful test. The negative tone is a warning to check the Tester or connections.
Communication Settings
FC-Devices (1673 FC/1674 FC)
The Tester can connect to both the 1630-2 FC Earth Ground Clamp and 369 FC Leakage
Current Clamp Meter. When connected to these tools you can remotely view and save
measurements.
Measurements from the paired tools can be seen in the FC Connect screen or in the case of
the Fluke 1630-2 FC, also in the R
E
function.
To p a i r y o u r d e v i c e :
1. Push
O.
2. Select Device Settings > Communication Settings > FC - Devices.
3. Select and pair the device from the display.
4. Select
C in the functions menu to go to the Fluke Connect screen.
To Next Page
