Multifunction Tester
Programmed Autotest Sequence (1674 FC)
59
Programmed Autotest Sequence (1674 FC)
The programmable Autotest is a custom automatic test sequence.
With this feature you have the versitilty to:
choose the test order
pause the test
restart the test
This allows you to set up the test according to special requirements such as energize, de-
energize, or manipulate a circuit before you finish the complete sequence of measurements.
To create or edit a custom Autotest:
1. Push
I.
2. Select Auto Test.
3. Select the custom number you want to save the auto sequence to.
If the custom sequence contains saved tests, the details show on the left side of the
display. This area is empty if no tests are assigned.
To add a new test:
1. Select Add function and choose the function to add from the pop-up list.
2. Select the settings.
3. Tap
2 to exit the setup screen.
Repeat these steps to add more tests.
To edit or remove a function:
1. Select the test.
2. Change the settings or select Remove function.
To Next Page
