1672/1673 FC/1674 FC
Users Manual
64
Autotest/Edit/Details
Autotest. When Distribution Boards, Circuits, or Test Point is selected, you can initiate an
automatic test sequence and the measurements automatically transfer to the selected test
points when you save the test.
Edit. Allows you to edit or delete the selected test point.
Details. Shows metadata for the selected point and the options to add a note to the test point
or delete the test point.
Note
The display header indicates information about the client, site, and project selection.
Review a Measurement
To review a measurement:
1. Tap
q to open the System Settings Menu.
2. Tap QuickSave Overview.
3. Swipe on the horizontal and vertical scroll bars to view all available files.
4. Tap on the file icon to view the measurement summary.
5. Tap to go back to the overview page.
Clear Memory
To c l e a r m e m o r y :
1. Press
O to open the Main Menu.
2. Go to Device Settings > System Settings > Memory Management.
The Testers show a list of options:
Remove all projects
Remove all clients
Remove all custom autotests
Factory Reset
3. Tap the option.
A pop-up message asks you to confirm or cancel.
To Next Page
