Fluke 1672 - Create Client, Sites, and Projects; Client; Site

Multifunction Tester
Form Mode
61
3. Sites contain Project
Note
You can create a Project without a Client or Sites. When you transfer this type of
Project to the TruTest software, manual data entry is required for the Client and Sites
information.
4. Project contains the installation data that includes the distribution board, circuits, and test
points.
Note
You can use metadata to create the distribution board and circuits and use this data to
calculate the test limit.
Create Client, Sites, and Projects
To open a Form:
1. Push
K.
2. On the display, tap
M.
3. Select Add Project.
4. Select Client or Project.
5. Select Add+.
Client
To add client information:
1. Enter Client information.
Client code and Name are mandatory fields (*).
2. Tap Accept.
Site
To add site information:
1. Select Client.
2. Select Add+.
3. Enter Site information. Site code and name are mandatory fields (*)
4. Tap Accept.