Fluke 1672 - Form Mode; Create a Form

1672/1673 FC/1674 FC
Users Manual
60
Form Mode
The Tester supports 2-way communication with TruTest software and Fluke Connect to
transfer forms and create reports. Standard forms are available by certificate type and include
the measurement requirements.
These certificate types are available:
 European Standard IEC/HD 60364-6
 United Kingdom – BS7671, 18
th
Edition
 International Standard
The certificate type is selected when you set the region. See Localization.
The flows that you can set are:
 British standard
 all other standards
Choose the British standard to make the form view in the device look similar to the British
standard form.
The device will provide for the user guidance on what measurements should be taken for a
specific circuit. An example is when an RCD type with 0.03A with a report NEN-1010 is
selected, the test required is an RCD Trip test on 30 mA with all predefined settings according
to the standard.
The certificate itself will be created by TruTest software by forwarding the measured results to
the application. The files can be transferred using the USB cable. See Download Test Results.
Create a Form
The form is setup from a Project or as a structured hierarchy that allows you to filter the
contents by client and site.
The form is always structured with this hierarchy:
1. Client
2. Client contains Sites