Fluke DTX-GFM2 - Page 258

DTX Series CableAnalyzer
Technical Reference Handbook
13-4
Updating with Another Tester
You can update a tester’s software using another tester
that is already updated.
1 Use link interface adapters to connect an updated
tester or smart remote to a tester or smart remote that
needs updating (Figure 13-2).
Note
One of the units must be a main tester.
2 Turn on both units; then press Pon either.
3 The testers compare software versions. If one has more
recent software, the main tester prompts you about
updating the older software.
4 Press K OK to start the update process.
5 To verify the update, turn the rotary switch to SPECIAL
FUNCTIONS; then select Version Information.
amd73f.eps
Figure 13-2. Updating the Software with
an Updated Tester
TEST
LOW BATTERY
TONE
TALK
FAIL
TEST
PASS
TALK
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3
TALK
MONITOR
ENTER
TEST
SAVE
SPECIAL
FUNCTIONS
SETUP
AUTO
TEST
SINGLE
TEST
EXIT
F1 F2
F3