EasyManuals Logo

Flux Beambox User Manual

Flux Beambox
103 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
87
󱦿
Place the laser tube into the chassis. Make sure
the gap is wider than a finger on both ends of the
tube. The terminal on the laser tube which connected
to the thick red wire should point upward. Install the
screws of the tube holder clip and make sure the tube
is fastened firmly.
Make sure the terminal of the red cable points
upward instead of other angles. Do not let the end of
the tube touch or near the side of the chassis. Wrong
placement for the tube may cause voltage leak.

Other manuals for Flux Beambox

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Flux Beambox and is the answer not in the manual?

Flux Beambox Specifications

General IconGeneral
Laser Power40W
Weight22 kg (48.5 lbs)
Laser TypeCO2
CameraYes
ConnectivityWi-Fi
Supported File TypesSVG, DXF, JPG, PNG
Power Supply110V/220V

Related product manuals