Original User Guide | Impulse Evo pedelec Version 2 US-25
4. Turn the clamping nut clockwise to tighten it. You may need to keep
the nut on the other side in place with a second key. Observe the
correct torque setting.
5. Ensure that the newly-tightened saddle does not tip; test it by pressing
down on the front and back alternately.
3.3.4 Suspension seatpost
WARNING
If your bike is equipped with a suspension seat post, the suspension
mechanism may require periodic service or maintenance. Ask your
dealer for recommended service intervals for your suspension seat
post.
3.4 Handlebars
WARNING
Make sure the stem and the handlebars are at the right height for you.
Make sure the saddle and handlebar stem are parallel to the bike’s
center line and clamped tight enough so that you can’t twist them out
of alignment.
Aninsucientlytightenedstemclampbolt,handlebarclampboltor
bar end extension clamping bolt may compromise steering action,
which could cause you to lose control and fall. Place the front wheel
of the bike between your legs and attempt to twist the handlebar/stem
assembly. If you can twist the stem in relation to the front wheel, turn
the handlebars in relation to the stem, or turn the bar end extensions
inrelationtothehandlebar,theboltsareinsucientlytightened.
3.4.1 Adjusting the height and angle of the handlebars
WARNING
Ask your dealer to do this, otherwise there is a risk of the handlebars
loosening, leading to falls and serious injuries.
3.5 Turn lights *
On the back of the front light there is a slider. Depending on the direction
you push the slider, the front and rear lights are either ON or OFF during
travel.
*depending on model
To Next Page
Loading...