EasyManua.ls Logo

Focus IMPULSE EVO PEDELEC - Cleaning; Storage

Focus IMPULSE EVO PEDELEC
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Original User Guide | Impulse Evo pedelec Version 2 US-77
7.4.2 Storage
1. Remove the battery from the pedelec.
2. Store the battery in a dry, but not too warm place. The battery
must not be exposed to direct sunlight. The recommended storage
temperature is between 32 and 68 °F.
NOTICE
The battery should not be stored in a fully charged state. It then ages
faster. A charge level of 50– 70% (

) is ideal. Since the battery
loses charge very slowly, you should only recharge it when only one or
two LEDs come on, but after six months at the latest.
7.4.3 Cleaning
WARNING
If you wipe the battery avoid touching the contacts, otherwise there is
the risk of an electric shock.
Remove the battery from the pedelec before cleaning. There is a risk
of injury due to accidental activation of the
button.
Batteries must not be immersed in water. There is a risk of explosion.
Do not extinguish a burning battery with water, only the surrounding
burning material. Class D extinguishers (metal powder type) are
better suited for this. If it is possible to take the battery safely
outside,smothertherewithsand.Youneedhavenoworriesthatthe
battery beneath you could explode while you are riding in the rain– it
is protected from ingress of moisture and/condensation.
NOTICE
Do not clean the battery with a water hose or high pressure washer.
You could still damage the battery. Clean the battery with a soft, damp
cloth.
Do not use any cleaners containing alcohol, solvents or that have a
scouring action. Nor should you use coarse sponges or brushes; you
will scratch and tarnish the surface. Clean the battery with a soft,
damp cloth.
Do not let dirt dry out. Ideally, you should clean the bike
straight after the trip.
1. Remove the battery from the pedelec.
2. Clean the casing with a soft, damp cloth.
3. If the contacts are dirty, clean them with a soft dry cloth.

Table of Contents