Focus IMPULSE EVO PEDELEC - Page 37

Original User Guide | Impulse Evo pedelec Version 2 US-37
Quick-release lever shuts too easily 1. Open the quick-release lever.
2.
Hook the quick-release lever into the slot
and turn it clockwise. This screws the axle
into the thread. Ensure that your wheel is
centered.
3.
Close the quick-release lever.
4.
Repeat if necessary.
Quick-releaselevertoosti 1. Open the quick-release lever.
2.
Hook the quick-release lever into the slot
and turn it counter-clockwise until the
quick-release axle sticks out about 1 cm
from the axle hole.
3.
Close the quick-release lever.
4.
Repeat if necessary.
WARNING
Reattach the previously disconnected cables (e.g. lighting cables) to
the wheel, otherwise they could tear.
Replacing the front wheel
1. Apply a thin layer of grease to the
quick-release axle.
2. Push the wheel into the front forks
and align with the axle holes.
3. Reinsert the quick-release axle.
4. Move the quick-release lever to the open position.
5. Hook the quick-release lever into the slot and turn it clockwise.
This screws the axle into the thread. Make sure that your wheel is
correctly centered.
6. Closethequick-releaseleverbyturningitup180˚.
WARNING
Closing the quick-release lever should be so hard that you need to use
the ball of your hand to do it. If not,
it can open and loosen the wheel,
whichcouldresultinyoufallingothebike.
Quick-release clamps
For6. Close quick-release lever