Follett 25CI400A - Page 12

12 25CI400A/W • 25HI400A • 50CI400A/W • 50HI400A
Sanitize ice machine
14. Submerge ice compression nozzle and drain lines in a cup of Solution B while following steps 15-21.
15. Connect ice transport tube directly onto evaporator outlet port without ice compression nozzle.
16. Fill reservoir almost to over owing with Solution B.
17. Restore power to ice machine (gearmotor will run; compressor and fan will not).
18. After 10 minutes, turn compressor switch to ON position.
19. As unit starts to make ice, continue to pour Solution B into reservoir, maintaining level just below reservoir
over ow.
20. Continue to make ice with Solution B for 20 minutes.
21. Turn power to ice machine OFF.
22. Disconnect ice transport tube from evaporator outlet port. Rinse ice compression nozzle and drain lines in
clean water and reinstall on evaporator outlet. Reconnect ice transport tube to ice compression nozzle.
23. Drain any remaining Solution B from evaporator.
24. Fill reservoir almost to over owing with 120 F (49 C) clean water to rinse. Drain. Repeat two more times.
Re-clamp pinch clamp, replace drain plug, and re-secure drain tube ensuring that end of drain tube is
above water level in reservoir.
25. Open water supply valve (or unblock  oat) and replace reservoir cover; restore power to ice machine and
ensure compressor switch is in ON position. Make ice for at least 15 minutes to  ush any remaining
Solution B from system (RIDE
®
ice machines with long ice transport hoses may take longer to  ush out).
Discard this ice and all ice made during sanitizing.
Clean/descale dispenser
26. Remove and discard all ice from storage hopper.
27. Ensure power is disconnected. Working inside storage area, remove center thumbscrew from dispense
wheel, tilt wheel up toward back to clear baffle and disengage wheel from motor shaft.
28. Remove dispense chutes.
29. Thoroughly wipe lid, dispense wheel, baffle and dispense chutes with cloth soaked in SolutionA.
30. Wipe all bin surfaces (including the area under dispense wheel) with a damp cloth wrung out in Solution A.
Note: To avoid possible damage to dispense motor assembly, use only a damp cloth to clean the storage bin. Do not
allow water to run through bottom of bin area.
31. Remove grille and wash with Solution A. Rinse thoroughly with clean water.
32. Rinse all above items with damp cloth wrung out in clear water.
Sanitize dispenser
33. Wipe all above items with damp cloth wrung out in Solution B to sanitize. Do not rinse.
34. Reinstall all parts and replace any panels removed prior to cleaning.
35. Pour 1 gal. (3.8 L) of hot tap water into drain pan to  ush drains.
36. Turn ice machine ON and begin to make ice (ice machine should start immediately with power and bin
signal supplied).
37. After approximately 30 minutes, test dispenser for proper dispensing.