NOTE! Power cycle is required for the new settings to take eect.
Device Variables
This device does not expose any Device Variables.
Dynamic Variables
Four Dynamic Variables are implemented.
Status Information
Device Status
Bit 4 ("More Status Available") is set when any failure is detected. Command #48 provides additional
detail.
Extended Device Status
This bit is set if a sensor error is detected. "Device Variable Alert" is set if the Primary Variable (PV) is
out of limit.
Communications | 103
Model FT3
Communications
Variable Meaning Units
PV Flow Rate In Selected Units
SV Total In Selected Units
TV Temperature In Selected Units
QV Elapsed Time In Hours
To Next Page
Loading...
