COMPRESSION
FITTING
NUT
FLOW DIRECTION
ARROW
6. Insert probe back into the retractor to the depth mark and hand-tighten the compression tting.
7. Verify that ow direction indicator is in line with pipe and in the direction of ow.
Fig. 2.14: Installed Retractor
8. Fully tighten compression tting (refer to the instructions on p. 27).
NOTE! For instructions on how to properly remove and replace the meter from a retractor, please
refer to "Instructions for Removing and Inserting the Meter from a Pressurized Pipe using the
Retractor" on page 113.
Installation | 32
Model FT3
Installation
To Next Page
Loading...
