FOXTEL iQ
79
The FOXTEL iQ
v Connections to the FOXTEL iQ
The connection diagram is shown on page 80.
WARNINGS
You must not plug the FOXTEL iQ into the mains supply until you
have connected the FOXTEL iQ to the other equipment in your
system.
The FOXTEL iQ is designed for use only with the supplied external
power supply adapter. On the external power supply adapter there is a
label that specifies the correct mains power supply input for it. Do not
connect the external power supply adapter to any other power supply.
After connecting all other equipment, connect the 12 Volt lead to the
FOXTEL iQ and then insert the external power supply adapter into the
power point.
The only way to disconnect the FOXTEL iQ from the power supply is to
remove the external power supply adapter from the power point (i.e.
not by removing the 12 Volt lead from the FOXTEL iQ). Therefore you
must install the FOXTEL iQ near to the power point, which should be
easily accessible.
If you are in any doubt about the external power supply adapter or
its connection, consult a competent electrician.
To Next Page
Loading...
