SETUP
71
Setup
Audio and Language Settings
The standard (default) setting for each item is marked with *.
To confirm any changes, highlight ‘Save New Settings’ then press
select, or to cancel, press back.
If you press the red (Reset all settings) button, the settings will
change to the
standard
settings (
NOT
the settings made by the
installer).
Item Settings Comments
Audio output Stereo *, Mono Controls the audio output on the SCART lead.
Background music On *, Off Controls whether or not music will play while you look at
the FOXTEL Guide.
Incorrect PIN signal On *, Off Controls whether or not a ‘beep’ noise will sound if you
enter an incorrect PIN.
SPDIF Digital Audio
Output
AC3 *, MPEG Controls the digital audio output from the connectors
marked ‘OPTICAL AUDIO OUT’ and DIGITAL AUDIO OUT’.
Select AC3 if your equipment has Dolby Digital decoding
capabilities. The setting ‘MPEG’ is for digital stereo sound.
Note: Dolby Digital is only available on some rogrammes.
If DolbyDigital is not available, the audio output will be
digital stereo.
SPDIF Digital Audio
Delay
0ms*, 10ms,
20ms, 30ms,
40ms, 50ms,
60ms, 70ms,
80ms, 90ms,
100ms
Televisions take time to process a Digital HDMI input,
this can result in the audio being ahead of the video
if an external Dolby Digital decoder is being used. This
setting allows you to delay the audio to match up with
the video.
HDMI Digital Audio
Output
MPEG*, AC3 Controls the digital audio output from the HDMI
connector.
Preferred Language English Choose your preferred language for programmes or
channels where more than one language is available.
To Next Page
Loading...
