freightliner Sprinter 2015 - Windshield Wipers

Perimeter lamp (Cab Chassis)
Type of lamp: W 5 W
X
Switch off the lighting system.
X
Undo screws : and remove the lamp unit.
X
Turn bulb holder ; and remove it.
X
Remove the bulb from bulb holder ;.
X
Press the new bulb into bulb holder ;.
X
Screw bulb holder ; into the lamp unit.
X
Carefully position the lamp housing and
tighten screws :.
Courtesy lights, rear compartment
Bulb type: W5W
X
Press in the latching spring of courtesy
light : with a suitable implement, e.g. a
screwdriver.
X
Pry off courtesy light :.
X
Disconnect cable connector =.
X
Unscrew bulb holder ;.
X
Remove the bulb from bulb holder ;.
X
Press the new bulb into bulb holder ;.
X
Screw bulb holder ; into courtesy
light :.
X
Connect cable connector =.
The connector locking spring must engage.
X
Align courtesy light : on the side and
engage.
Interior lighting
General notes
!
Have the bulbs in the overhead control
panel replaced at a qualified specialist
workshop. You could otherwise damage
the overhead control panel.
Front interior light
Type of lamp: K 18 W
X
Switch off the interior lighting.
X
Press spring catch ; in the direction of the
arrow and lift off interior light :.
X
Remove bulb = from the bulb holder.
X
Insert new bulb =.
X
Align interior light : on the right-hand side
and engage the spring catch.
Changing bulbs
105
Lights and windshield wipers
Z