freightliner Sprinter 2015 - On-Board Computer (Vehicles Without Steering Wheel Buttons)

Menus in the on-board computer
Overview
If you wish to exit a menu and go to the stand-
ard display:
X
Press the 4 menu button for longer than
1 second.
or
X
Do not press any button for 10 seconds.
The display accepts the changed settings.
Using the f, g, 4 or 9 adjustment but-
tons, you can select the following functions:
R
Calling up the service due date
(Y page 258)
R
Checking the oil level (Y page 250)
R
Checking the DEF supply (Y page 182)
R
Preselecting/setting the auxiliary heating
switch-on time (Y page 124)
R
Tire pressure monitor (Y page 291)
R
Setting the time (Y page 183)
R
Activating/deactivating Highbeam Assist
(Y page 192)
R
Setting the daytime running lamps
(Y page 92)
Setting the time
X
Turn the key to position 2 in the ignition
lock.
X
Press the 4 menu button repeatedly until
the hours figure flashes.
X
Press the f or g button to set the hour.
X
Press the 9 reset button.
The minute display flashes.
X
Press the f or g button to set the minute.
i
If you keep the f or g button pressed,
the value will change continuously.
Activating/deactivating Highbeam
Assist
X
Turn the key to position 2 in the ignition
lock.
X
Press the 4 menu button repeatedly until
the _ indicator lamp flashes and the onon
or OFFOFF message appears in the display.
X
Use the f or g button to switch High-
beam Assist on/off.
Switching the daytime running lamps
on/off
If you switch the daytime running lamps onon,
the daytime running lamps will automatically
light up when the engine is running.
For safety reasons, it is only possible to
change this setting when the vehicle is sta-
tionary. The factory setting is onon in countries
in which daytime running lamp mode or day-
time running lamps are mandatory.
X
Turn the key to position 2 in the ignition
lock.
X
Press the 4 menu button repeatedly until
the L indicator lamp flashes and the onon
or OFFOFF message appears in the display.
X
Press the f or g button to activate or
deactivate the daytime running lamps.
i
USA only:
If you turn the light switch to T or L,
the corresponding light switches on. If you
turn the light switch to Ã, the daytime
running lamps remain switched on.
Canada only:
If you turn the light switch to L, the low-
beam headlamps switch on. If you turn the
light switch to T or Ã, the daytime
running lamps remain switched on.
On-board computer (vehicles without steering wheel buttons)
183
On-board computer and displays
Z