Switching the rear window wiper on/
off
Combination switch
:
è Rear window wiper switch
2
ô To wipe with washer fluid
3
I To switch on intermittent wiping
4
0 To switch off intermittent wiping
5
ô To wipe with washer fluid
X
Turn the key to position 1 or 2 in the ignition
lock.
X
Turn switch : to the corresponding posi-
tion
The rear window wiper switches on automat-
ically if you engage reverse gear and the wind-
shield wipers are on.
Replacing the wiper blades
G
WARNING
If the windshield wipers begin to move while
you are changing the wiper blades, you could
be trapped by the wiper arm. There is a risk of
injury.
Always switch off the windshield wipers and
ignition before changing the wiper blades.
!
Never open the hood if a windshield wiper
arm has been folded away from the wind-
shield.
Never fold a windshield wiper arm without a
wiper blade back onto the windshield/rear
window.
Hold the windshield wiper arm firmly when
you change the wiper blade. If you release
the windshield wiper arm without a wiper
blade and it falls onto the windshield, the
windshield may be damaged by the force of
the impact.
We recommend that you have the wiper
blades replaced at a qualified specialist
workshop.
!
Only hold the wiper blade by the wiper
arm. You could otherwise damage the
wiper rubber.
The windshield will no longer be wiped prop-
erly if the wiper blades are worn. Replace the
wiper blades twice a year, ideally in spring and
fall.
Front windshield wiper arm with wiper blade
X
Fold wiper arm = away from the wind-
shield.
X
Set wiper blade : at right angles to the
wiper arm.
X
Press both retaining clips ; together in
the direction of the arrow and swing wiper
blade : away from wiper arm =.
X
Pull wiper blade : up and out of the
retainer on wiper arm =.
X
Slide new wiper blade : into the retainer
on wiper arm =.
X
Press new wiper blade : onto wiper arm
= until you hear retaining clips ; engage.
X
Fold wiper arm = back onto the windshield
again.
108
Windshield wipers
Lights and windshield wipers
To Next Page
Loading...
