– 1.0 qts– 1.0 qts
X
Add the amount of oil
shown (Y page 252).
X
Check the engine oil level
again after a few minutes.
– 1.5 qts– 1.5 qts
– 2.0 qts– 2.0 qts
HIHI
The oil level is too high.
X
Have excess oil removed.
Measurement units in the display:
R
qtsqts USA only
R
ltrltr Canada only
Display message for vehicles with steer-
ing-wheel buttons: the display may show
the following messages after the engine oil
level measurement.
1
Action
EngineEngine
oil leveloil level
OKOK
X
Do not add oil.
EngineEngine
oil Addoil Add
1.0 quart1.0 quart
X
Add the amount of oil
shown (Y page 252).
X
Check the engine oil level
again after a few minutes.
EngineEngine
oil Addoil Add
1.51.5 quartsquarts
EngineEngine
oil Addoil Add
2.02.0 quartsquarts
EngineEngine
oil leveloil level
ReduceReduce
oil leveloil level
The oil level is too high.
X
Have excess oil removed.
Eng. oilEng. oil
lev. Turnlev. Turn
ignitionignition
on foron for
levellevel
X
Turn the key to position 2
in the ignition lock.
ObserveObserve
wait.wait.
periodperiod
X
Repeat the engine oil
measurement after about
5 minutes if the engine is
at normal operating tem-
perature.
X
Repeat the engine oil
measurement after about
30 minutes if the engine is
not at normal operating
temperature.
EngineEngine
oil leveloil level
Not whenNot when
eng. run‐eng. run‐
ningning
X
Switch off the engine
when it is at normal oper-
ating temperature and
wait approximately
5 minutes before measur-
ing the engine oil level.
Measurement units in the display:
R
qtsqts USA only
R
ltrltr Canada only
Checking the oil level using the oil dip-
stick
Example: 4-cylinder diesel engine
Engine compartment
251
Maintenance and care
Z