Setting the switch-on time
X
Use the same method to select a switch-on
time as described in the "Preselecting a
switch-on time" section.
On-board computer without steering
wheel buttons
X
Press the 9 reset button on the instru-
ment cluster.
The hour display flashes.
X
Use the f and g buttons on the instru-
ment cluster to set the hours.
X
Press the 9 reset button
The minute display flashes.
X
Use the f and g buttons to set the
minutes.
The switch-on time is set and selected.
On-board computer with steering wheel
buttons
X
Press the 9 button on the steering
wheel.
The display shows the HoursHours menu.
X
Use the W and X buttons on the
steering wheel to set the hours.
X
Press the 9 button.
The display shows the MinutesMinutes menu.
X
Use the W and X buttons to set the
minutes.
X
Press the V button.
The switch-on time is set and selected.
Operation with the remote control
Important information
You can switch the auxiliary heating on/off
and set the operating duration using the
remote control. You can use up to 4 remote
control units on the vehicle. These must be
synchronized for the receiver in your vehicle
(Y page 126).
The remote control has a maximum range of
approximately 600 meters. This range is
reduced by:
R
sources of interference
R
solid objects between the remote control
and the vehicle
R
the remote control being in an unfavorable
position in relation to the vehicle
R
transmitting from an enclosed space
Overview of the remote control
:
Indicator lamp
;
To confirm settings
=
To switch the remote control on/off, set
the operating duration or end or cancel
settings
Indicator lamp : lights up in various ways to
show different operating modes:
Signaling Meaning
Lights up red Remote control switched
on
Data transfer
Flashes red Auxiliary heating switched
off
Lights up
green
Auxiliary heating switched
on
Operating the auxiliary heating system
125
Climate control
Z
To Next Page
Loading...
