X
Clean all sensors : in the front and rear
bumpers with water, shampoo and a soft
cloth.
Cleaning the rear view camera
!
Do not use dry, coarse or hard cloths and
do not scrub. Otherwise, you will scratch or
damage the lens of the rear-view camera.
If you clean the vehicle with a high-pressure
or steam cleaner, maintain a distance of at
least 1.650 cm from the rear-view camera.
Do not aim directly at the rear-view camera
or at the microphone opening on the under-
side of the rear-view camera. You could
otherwise damage the rear-view camera.
Rear view camera in the middle of the roof above
the high-mounted brake lamp
:
Camera lens
;
Microphone openings
X
Clean camera lens : with clean water and
a soft cloth.
Make sure that you do not apply any wax to
camera lens : when waxing the vehicle. If
necessary, remove the wax using water,
shampoo and a soft cloth.
Cleaning the sliding door
X
Remove foreign objects from the vicinity of
the contact surfaces and contact pins of
the sliding door.
X
Clean the contact surfaces and contact
pins with a mild cleaning agent and a soft
cloth.
Do not oil or grease the contact plates and
contact pins.
Steps
Cleaning the electrical step
Clean the electrical step at least once a
month. Make sure that no dirt accumulates in
the housing or on the step.
X
Extend the electrical step (Y page 73).
X
Close the sliding door until the door lock
engages.
The electrical step remains extended for
cleaning.
X
Clean the electrical step and the housing
with a power washer.
X
After cleaning, spray the step guides on
each side with silicone spray when the
housing and electrical step are dry.
Do not use oil or grease as a lubricant.
X
Retract the electrical step.
Access step in the bumper
Example: access step in the bumper
Pay attention to the important safety notes in
the "Notes on care" (Y page 265) and "Power
washers" (Y page 266) sections.
Keep step in the bumper : free from dirt,
such as:
R
mud
R
clay
R
snow
R
ice
Care
269
Maintenance and care
Z
To Next Page
Loading...
