X
Press the W or X button to select the
Clock/DateClock/Date submenu.
X
Press the 9 button to select the
12/24 h12/24 h function.
The selection marker is on the current set-
ting.
X
Press the W or X button to select the
12 h12 h or 24 h24 h clock format.
Lighting submenu
Activating/deactivating Highbeam Assist
Using the steering wheel buttons
X
Press the V or U button repeatedly
until the SettingsSettings menu appears in the
display.
X
Press the 9 button to switch to the sub-
menu selection.
X
Press the W or X button to select the
LightingLighting submenu.
X
Press the 9 button to select the High‐High‐
beam Assistbeam Assist function.
The selection marker is on the current set-
ting.
X
Press the W or X button to switch
Highbeam Assist OnOn or OffOff .
i
For safety reasons, it is not possible to
reset the HighbeamHighbeam AssistAssist function to the
factory settings during a journey. You will
see the following message in the display:
Setting only possible at stand‐Setting only possible at stand‐
stillstill.
For further information about Highbeam
Assist, see (Y page 96).
Switching the daytime running lamps on/
off
If you switch the daytime running lamps func-
tion to OnOn, the daytime running lamps will
automatically light up when the engine is run-
ning.
For safety reasons, it is only possible to
change this setting when the vehicle is sta-
tionary. The factory setting is OnOn in countries
in which daytime running lamp mode or day-
time running lamps are mandatory .
Using the steering wheel buttons
X
Press the V or U button repeatedly
until the SettingsSettings menu appears in the
display.
X
Press the 9 button to switch to the sub-
menu selection.
X
Press the W or X button to select the
LightingLighting submenu.
X
Press the 9 button to select the Day‐Day‐
time runn. lampstime runn. lamps function.
The selection marker is on the current set-
ting.
X
Press the W or X button to switch
the daytime running lamps OnOn or OffOff.
i
If you turn the light switch to T or
L, the corresponding lamp switches on.
If you turn the light switch to Ã, the
daytime running lamps remain switched
on.
i
For safety reasons, it is not possible to
reset the Daytime runn. lampsDaytime runn. lamps function
to the factory setting while the vehicle is in
motion. You will see the following message
in the display: Setting only possibleSetting only possible
at standstillat standstill.
192
On-board computer (vehicles with steering wheel buttons)
On-board computer and displays
To Next Page
Loading...
