Useful information
This Operator's Manual describes all models
as well as standard and optional equipment of
your vehicle that were available at the time of
going to print. Country-specific variations are
possible. Note that your vehicle may not be
equipped with all of the described functions.
This also applies to systems and functions
relevant to safety.
Read the information on qualified specialist
workshops (Y page 25).
Exterior lighting
Important safety notes
For reasons of safety, we recommend that
you drive with the lights switched on even
during the daytime. There may be differences
in operation due to legal requirements and
voluntary recommendations in some coun-
tries.
Bulb failure indicator
The bulb failure indicator is only an aid. You
are responsible for the proper functioning of
the vehicle lighting. Insufficient or non-func-
tioning vehicle lighting puts the operating
safety of the vehicle at risk.
For this reason, check the condition and func-
tion of your vehicle's lighting system and, if
necessary, that of the trailer before each jour-
ney.
The bulb failure indicator monitors all of the
exterior lighting lamps, except the perimeter
lamp and the trailer lighting. If a bulb fails,
either the b(Y page 35) indicator lamp
lights up, or you will see a corresponding
message in the display (Y page 208).
i
Depending on the equipment, the bulb
failure indicator can fail for all lamps with
the exception of the turn signal lamps.
Light switch
Operation
1 Ã
Automatic headlamp mode/
daytime running lamps
2 $
Lights off
3 T
Parking lamps, license plate and
instrument lighting
4 L
Low-beam/high-beam headlamps
5 N
Fog lamps
6 R
Rear fog lamp
If you hear a warning tone when you leave the
vehicle, the lights may still be switched on.
X
Turn the light switch to $ or Ã.
or
X
If the rear fog lamp is switched on: press
the light switch in to the stop.
The turn signals, high-beam headlamps and
the high-beam flasher are operated using the
combination switch (Y page 94).
Low-beam headlamps
X
To switch on: turn the key to position 2 in
the ignition lock or start the engine.
X
Turn the light switch to position L.
The L indicator lamp in the instrument
cluster lights up.
Daytime running lamps
You can activate/deactivate the daytime run-
ning lamps function using the on-board com-
puter.
92
Exterior lighting
Lights and windshield wipers
To Next Page
Loading...
