freightliner Sprinter 2015 - Page 316

X
Raise spare wheel bracket A with the
pump lever and attach right-hand retaining
hook =.
X
Slightly raise spare wheel bracket A and
attach left-hand retaining hook =.
X
Pull the pump lever out of sleeve ?.
X
Using the lug wrench, tighten the retaining
hook bolts by turning them clockwise.
X
Replace and engage covers :.
X
Close the rear doors.
Cab Chassis version
Removing
X
Loosen fender nuts = manually and then
remove them.
X
Loosen nuts ; as far as the thread end.
X
Slightly raise spare wheel bracket ? and
unhook left-hand retaining hook :.
X
Assemble the pump lever for the jack and
slide it into the sleeve on the right-hand
side of spare wheel bracket ?.
X
Raise spare wheel bracket ? with the
pump lever and unhook right-hand retain-
ing hook :.
X
Slowly lower spare wheel bracket ? down
to the ground.
X
Lift spare wheel bracket ? slightly and pull
the pump lever out of the sleeve.
X
Use the pump lever to lift the spare wheel
beyond the rear edge of spare wheel
bracket ?.
X
Carefully remove the spare wheel from the
bracket.
The spare wheel is heavy. When the spare
wheel is removed, the center of gravity
changes due to the heavy weight of the
wheel. The spare wheel may slip down or tip
over.
Installing
X
Carefully place the spare wheel onto spare
wheel bracket ?.
The spare wheel is heavy. When you place
the spare wheel onto spare wheel
bracket ?, the center of gravity changes
due to the weight of the wheel. The spare
wheel may slip down or tip over.
X
Raise spare wheel bracket ? with the
pump lever and attach right-hand retaining
hook :.
X
Slightly raise spare wheel bracket ? and
attach left-hand retaining hook :.
X
Pull the pump lever out.
X
Tighten nuts ;.
X
Put fender nuts = in place and tighten
them.
314
Spare wheel
Wheels and tires