Fronius CL - Installing DC Filters

119
EN-US
Remove the cable tie holder of the line
from the plate
Disconnect all lines (10) and (11) from
the DC filter
Remove TX25 screws (8)
Loosen the 3 rear fastening screws (9)
of the DC filter
Pull-out the DC filter in a forward moti-
on
Installing DC fil-
ters
Install new DC Filter and secure using
the rear (9) and front (8) TX 25 screws
– 2.5 Nm
Connect all disconnected lines (10) –
30 Nm and (11)
6
(8) (8) (8) (10)(11)
(9)(10) (9) (9)
8
9
10
11
11
(8) (8) (8) (10)(11)
(9)(10) (9) (9)
1
2