Fronius Robacta Reamer V Easy Operating Instructions

Installation and commissioning 35
Safety 37
Safety 37
Ensuring that the cleaning device is depressurised 38
Before commissioning 39
Proper use 39
Operators, maintenance personnel 39
Setup regulations 39
Compressed air supply specifications 39
Measures for the safe operation of the device with untrained personnel 40
Screwing the Robacta Reamer V Easy, Robacta Reamer V to the underlying surface 41
Screwing the cleaning device and installation stand to the underlying surface 41
Screwing the cleaning device to the underlying surface 42
Screwing the Robacta Reamer V Easy Han6P J to the underlying surface 44
Screwing the adjusted cleaning device and installation stand to the underlying surface 44
Torch cleaning position 46
Welding torch cleaning position 46
Adjust gas nozzle clamping device 47
Adjusting the gas nozzle clamping device 47
Fitting the cleaning cutter 48
General 48
Fitting the cleaning cutter 48
Adjusting the lifting device 49
Adjusting the lifting device 49
Installing a mechanically or electrically-controlled wire cutter on the Robacta Reamer V Easy 50
Installing the mechanically controlled wire cutter 50
Installing the electrically-controlled wire cutter 51
Installing a mechanically or electrically-controlled wire cutter on the Robacta Reamer V 52
Installing the mechanically controlled wire cutter 52
Installing the electrically-controlled wire cutter 53
Installing the adjusted wire cutter 54
Fitting mounting plates for the wire cutter 54
Installing the adjusted wire cutter 54
Wire cutter function 56
Maximum wire diameter 56
How the mechanically-controlled wire cutter works 56
How the electrically-controlled wire cutter works 56
Installing the compressed air supply 57
Establishing the compressed air supply for the cleaning device, function of the compressed air
relief valve
57
Starting up the parting agent nebuliser 58
Fill parting agent container (1 litre) and connect to the cleaning device 58
Connect the parting agent container (10 litres) to the cleaning device 58
Adjusting the parting agent nebuliser spray amount 59
Using the fill-level control sensor 61
General 61
Controls and indicators on the sensor 61
Installation adapter borehole dimensions 61
Fitting the fill-level control sensor 62
Calibrating the empty state 63
Calibrating the full state 63
Locking/unlocking the fill-level control sensor 64
Electrical connection 64
Separating GND for actuators and sensors (Robacta Reamer V only) 65
General 65
Separating GND for actuators and sensors (Robacta Reamer V) 65
Separating GND for actuators and sensors (electrically controlled wire cutter on the Robacta
Reamer V)
66
Checking the Robacta Reamer V Easy and Robacta Reamer V Easy Han6P J functions 67
Safety 67
Manually checking the Robacta Reamer V Easy and Robacta Reamer V Easy Han6P J functions 67
4

Fronius Robacta Reamer V Easy Specifications

General

Brand	Fronius
Model	Robacta Reamer V Easy
Category	Welding System
Language	English