Fronius Robacta Reamer V Easy - Page 74

Query output (Gas nozzle free
output signal)
- Low or High
Start from position A
- c. 50 mm (1.97 in.) centrally
above the cleaning device
- Speed: high speed
Query = High
(Gas nozzle free)
Query = Low
(Gas nozzle clamped)
Stop
Set
- Input "Start cleaning"
Reset
- Input "Start cleaning"
Reset
- Blow compressed air through
welding torch
Start from position B
(cleaning position)
- Enter gas nozzle clamping device
- Speed: 10 cm/s
(236.22 ipm)
Set
- Blow compressed air through welding
torch
Wait 5 sec.
Wait 1.5 sec.
74