Fronius Robacta Reamer V Easy - Page 76

Cleaning pro-
gram on the
Robacta Reamer
V
Start from position C
- c. 25 mm (0.98 in.) next to wire
cutter
- Speed: high speed
Start
Query - wire cutter open =
Low
Query - wire cutter open
- Low or High
Query - wire cutter open =
High
Reset
- Signal "Cut wire electrode"
Query - wire cutter open
- Low or High
Query - wire cutter open
= Low
Stop
Error message – wire cutter not open
Start from position D
- Enter wire cutter
- Speed: 10 cm/s
(236.22 ipm)
Set
- External signal "Cut wire electrode"
Wait 0.5 sec.
Reset
- External signal "Cut wire electrode"
Query - wire
cutter open =
High
Wire cutter option
Start from position E
- c. 50 mm (1.97 in.) centrally
above the wire cutter
- Speed: 10 cm/s
(236.22 ipm)
76