13 SEP 12
/ Battery Charging Systems / Welding Technology / Solar Electronics
CMT
CMTCMT
CMT-
--
-Pulse Indicator
Pulse IndicatorPulse Indicator
Pulse Indicator
This will light when a CMT-Pulse
synergic line has been selected.
Wire Diameter Indicator
Wire Diameter IndicatorWire Diameter Indicator
Wire Diameter Indicator
When lit, this will indicate which wire
diameter is selected to weld with.
Wire Diameter Special Indicator
Wire Diameter Special IndicatorWire Diameter Special Indicator
Wire Diameter Special Indicator
When lit, this indicates that a size other
than the normal ones are selected to
weld with.
Filler Metal/Gas Indicator
Filler Metal/Gas IndicatorFiller Metal/Gas Indicator
Filler Metal/Gas Indicator
When lit, this indicates the shielding gas and
filler metal combination used during the
welding process.
Trigger Indicators
Trigger IndicatorsTrigger Indicators
Trigger Indicators
These indicators determine how the torch trigger reacts
during the welding process.
Conventional
ConventionalConventional
Conventional: Press and hold torch trigger to start
arc. Release trigger to stop.
Trigger Lock (
Trigger Lock ( Trigger Lock (
Trigger Lock ( 2-step⁄
⁄⁄
⁄: Press and release torch
trigger to start arc. Press (and release⁄ trigger to
stop arc.
Special 4
Special 4Special 4
Special 4-
--
-Step:
Step:Step:
Step: Press and hold torch trigger to begin
welding at Current start value. Release trigger to
move to normal welding current. Press and hold
trigger to move to ending current value. Finally,
release torch trigger to stop the arc.
Spot Mode
Spot ModeSpot Mode
Spot Mode: Press and release torch trigger to start
the weld, it will run until the time runs out and then
stop automatically. You can abort the weld by
pressing and releasing the torch trigger a second
time.
Filler Metal/Gas Special Indicator
Filler Metal/Gas Special IndicatorFiller Metal/Gas Special Indicator
Filler Metal/Gas Special Indicator
When lit, this indicated that a special filler
metal/gas combination has been selected.
These two lines generally vary based on the
synergic data loaded into the power source.
Mode Indicators
Mode IndicatorsMode Indicators
Mode Indicators
These indicators determine which welding mode the power
source is in for welding.
Pulse Synergic:
Pulse Synergic:Pulse Synergic:
Pulse Synergic: This will set the power source
for welding in pulse MIG welding using stored
synergic line.
Synergic:
Synergic:Synergic:
Synergic: This will set the power source for
conventional MIG welding using a stored
synergic line.
CMT / CMT Pulse:
CMT / CMT Pulse:CMT / CMT Pulse:
CMT / CMT Pulse: This mode will set the
power source for CMT and CMT Pulse using
selected synergic lines.
STANDARD:
STANDARD:STANDARD:
STANDARD: This will set the power source for
conventional MIG welding using NO synergic
lines.
JOB:
JOB:JOB:
JOB: This will set the power source for welding
based on the JOB previously set up (there will
be a second indicator showing the saved
mode for the JOB⁄.
Stick:
Stick:Stick:
Stick: This will set the power source for Stick
(CV⁄ welding.
-
--
- 47
47 47
47 -
--
-
Use and Operation
Front Panel – Indicators (CMT)
To Next Page
Loading...
