Fronius TPS 3200 MV - PPU - Additional Information; PPU Number for Push Pull Torch; PPU Error Codes

13 SEP 12
/ Battery Charging Systems / Welding Technology / Solar Electronics
PPU Number for Push Pull Torch
PPU Number for Push Pull TorchPPU Number for Push Pull Torch
PPU Number for Push Pull Torch
PPU 2
PPU 2 PPU 2
PPU 2 

 Fronius KD Drive push-pull
PPU 3
PPU 3 PPU 3
PPU 3 

 Fronius Robacta Drive, master (3.5m or more⁄
PPU 4
PPU 4 PPU 4
PPU 4 

 Fronius Robacta Drive, slave (less than 3.5m⁄
PPU 5
PPU 5 PPU 5
PPU 5 

 Fronius PullMig, with potentiometer
PPU 6
PPU 6 PPU 6
PPU 6 

 Fronius PullMig, without potentiometer
PPU 16
PPU 16 PPU 16
PPU 16 

 MK Cobra Gold
PPU 26
PPU 26 PPU 26
PPU 26 

 MK Python
PPU 28
PPU 28 PPU 28
PPU 28 

 Fronius CMT PullMIG, with potentiometer
PPU 29
PPU 29 PPU 29
PPU 29 

 Fronius CMT PullMIG, without potentiometer
PPU 50
PPU 50 PPU 50
PPU 50 

 Fronius PT Drive, .030 aluminum
PPU 51
PPU 51 PPU 51
PPU 51 

 Fronius PT Drive, .040 aluminum
PPU 52
PPU 52 PPU 52
PPU 52 

 Fronius PT Drive, .045 aluminum
PPU 53
PPU 53 PPU 53
PPU 53 

 Fronius PT Drive, 1/16 aluminum
PPU 59
PPU 59 PPU 59
PPU 59 

 Fronius PT Drive, .040 steel
PPU 60
PPU 60 PPU 60
PPU 60 

 Fronius PT Drive, .045 steel
PPU 61
PPU 61 PPU 61
PPU 61 

 Fronius PT Drive, .030 steel
Processes
PPU - Additional Information
PPU Error Codes
PPU Error Codes PPU Error Codes
PPU Error Codes
Err Eto  Incorrect measurement during PPU alignment
St1 E1  No feedback from wire-feeder motor at min speed
St1 E2  No feedback from wire-feeder motor at max speed
St1 E3  No feedback from wire-feeder motor at min speed
St1 E4  No feedback from torch motor at min speed
St1 E5  No feedback from wire-feeder motor at max speed
St1 E6  No feedback from torch motor at max speed
St1 E16  PPU alignment interrupted by torch trigger press
St2 E7  PPU open drive roll has not been accomplished
St2 E8  No feedback from wire-feeder motor at min speed
St2 E9  No feedback from torch motor at min speed
St2 E10  Wire-feeder motor current out of range at min speed
St2 E11  Torch motor current out of range at min speed
St2 E12  No speed value from wire-feeder at max speed
St2 E13  No speed value from torch motor at max speed
St2 E14  Wire-feeder motor current out of range at min speed
St2 E15  Torch motor current out of range at max speed
St2 E16  PPU alignment interrupted by torch trigger press
-
--
- 52
52 52
52 -
--
-