13 SEP 12
/ Battery Charging Systems / Welding Technology / Solar Electronics
Program a Job
Program a JobProgram a Job
Program a Job
Step 1
Step 1Step 1
Step 1: Choose the desired synergic line.
Step 2
Step 2Step 2
Step 2: Dial in the desired power rating if known, if unknown
this step may be skipped.
Step 3
Step 3Step 3
Step 3: Press and release the STORE button. The first 3-
digit display should change to nPG and the second
should have a number on it. This is the first
available job number.
Step 4
Step 4Step 4
Step 4: Select the desired job number (note: if a job is
already saved, the first display will change to PrG.
Step 5
Step 5Step 5
Step 5: Press and hold the STORE button until the first
display changes from Pro to PrG. Release the
STORE button once this happens.
Step 6
Step 6Step 6
Step 6: Press and release the STORE button to return to
the main screen.
2/4
2/42/4
2/4
1/3/5/
1/3/5/1/3/5/
1/3/5/
6
66
6
Editing a Job
Editing a JobEditing a Job
Editing a Job
Step 1
Step 1Step 1
Step 1: Press and hold the STORE button and then press
the 1
st
PARAMETER SELECTION button. The
display should change to Job 0.
Step 2
Step 2Step 2
Step 2: Dial in the number of the job you wish to modify.
Step 3
Step 3Step 3
Step 3: Use the up/down arrows to cycle through the
available parameters until you find the one you wish
edit.
Step 4
Step 4Step 4
Step 4: Dial in the new value (note the starting value since
there is no way to undo a change⁄.
Step 5
Step 5Step 5
Step 5: Repeat steps 3 and 4 until all parameters have been
changed.
Step 6
Step 6Step 6
Step 6: Press and release the STORE button to return to
the main screen.
1
11
1
1 / 6
1 / 61 / 6
1 / 6
2 / 4
2 / 42 / 4
2 / 4
3
33
3
-
--
- 49
49 49
49 -
--
-
Processes
Job Programing and Editing
To Next Page
Loading...
