Fuji Electric Monitouch V9 Series - Page 118

4-4 4. JTEKT
PRG No. setting
If [Transmission Mode: Data Area Division] is set under [Communication Setting], specify a program number ([PRG No.]) in
addition to device type and address number. The assigned device memory is expressed as shown below when editing the
screen. The PRG No. is invalid for the device memory in the common area.
Indirect Device Memory Designation
* If [Transmission Mode: Data Area Division] is set under [Communication Setting], specify a program number ([PRG No.])
for the expansion code.
Specify the number obtained by subtracting “1” from the actual program number ([PRG No.]) as defined below.
PRG No. 1: 0
PRG No. 2: 1
PRG No. 3: 2
Example: 1: D0000
Address number
Device type
PRG No.: 1 to 3
15 8 7 0 15 8 7 0
n+0Model Device type n+0Model Device type
n+1 Address No. n+1 Lower address No.
n+2
Expansion code
*
Bit designation n+2 Higher address No.
n+3 00 Station number n+3
Expansion code
*
Bit designation
n+4 00 Station number
 For the address number of 0 to 65535:
 For the address number of 65536 or greater: