5.1 PLC Connection 5-11
5.1.7 KV-1000 (Ethernet TCP/IP)
Communication Setting
Editor
Make the following settings on the editor. For more information, see “1.3.2 Ethernet Communication”.
IP address for the V9 unit
- When specified on the screen program:
[System Setting] [Hardware Setting] [Local Port IP Address]
- When specified on the V9 unit:
Local mode [LAN Setting]
Port number for the V9 unit (for communication with PLC)
[System Setting] [Hardware Setting] [PLC Properties] [Communication Setting]
IP address and port number of the PLC
Register on the [PLC Table] in [System Setting] [Hardware Setting] [PLC Properties] [Target Settings].
PLC
The communication setting is the same as the one described in “5.1.5 KV-700 (Ethernet TCP/IP)”.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory TYPE Remarks
DM (data memory)
00H
R (input/output/internal auxiliary/special relay)
01H
TC (timer/current value)
02H
CC (counter/current value)
03H
TS (timer/set value)
04H
CS (counter/set value)
05H
T(timer/contact)
06H
C (counter/contact)
07H
TM (temporary data memory)
08H
CTH (high-speed counter/current value)
09H
CTC (high-speed counter comparator/set value)
0AH
CT (high-speed counter comparator/contact)
0BH
CR (control relay)
0CH
CM (control memory)
0DH
MR (internal auxiliary relay)
0EH
LR (latch relay)
0FH
EM (extended data memory 1)
10H
FM (extended data memory 2)
11H
Z (index register)
12H
To Next Page
Loading...