Fuji Electric Monitouch V9 Series - Fb100;Fb400;Fb900 (Modbus Rtu)

16-10 16. RKC
16.1.8 FB100/FB400/FB900 (MODBUS RTU)
Communication Setting
Editor
Communication setting
(Underlined setting: default)
FB100/FB400/FB900
The communication parameters can be set using keys attached to the temperature controller. Be sure to match the settings to
those made under [Communication Setting] of the editor.
Communication protocol (engineering mode F60)
* The temperature controller must be set to “STOP” (control stop) before making settings.
Communication parameter (setup setting mode)
(Underlined setting: default)
Parameter changes will take effect when the temperature controller is turned off and on again or is switched from “STOP” to
“RUN”.
Item Setting Remarks
Connection Mode
1 : 1 / 1 : n
/ Multi-link2 /
Multi-link2 (Ethernet) /
1 : n multi-link2 (Ethernet)
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 / 19200 / 38400 bps
Data Length 8 bits
Stop Bit 1
/ 2 bits
Parity None
/ Odd / Even
Target Port No. 1 to 31
Indication Item Setting Remarks
CMP1 Communication 1 protocol 1: MODBUS
CMP2 Communication 2 protocol 1: MODBUS
Port Indication Item Setting Remarks
Communication 1
Add1 Device address 1 1 to 31
Communication is not performed
when “0” is set.
bPS1 Baud rate 1
4.8: 4800 bps
9.6: 9600 bps
19.2:
19200 bps
38.4: 38400 bps
bIT1 Data bit configuration 1
8n1:
8 bits / none / 1 bit
8n2: 8 bits / none / 2 bits
8E1: 8 bits / even parity / 1 bit
8E2: 8 bits / even parity / 2 bits
8o1: 8 bits / odd parity / 1 bit
8o2: 8 bits / odd parity / 2 bits
InT1 Interval time 1 0 to 250 msec
Communication 2
Add2 Device address 2 1 to 31
Communication is not performed
when “0” is set.
bPS2 Baud rate 2
4.8: 4800 bps
9.6: 9600 bps
19.2:
19200 bps
38.4: 38400 bps
bIT2 Data bit configuration 2
8n1:
8 bits / none / 1 bit
8n2: 8 bits / none / 2 bits
8E1: 8 bits / even parity / 1 bit
8E2: 8 bits / even parity / 2 bits
8o1: 8 bits / odd parity / 1 bit
8o2: 8 bits / odd parity / 2 bits
InT2 Interval time 2 0 to 250 msec