Fuji Electric Monitouch V9 Series - Qnh (Q) Series (Ethernet)

9-18 9. MITSUBISHI ELECTRIC
9.1.8 QnH (Q) Series (Ethernet)
Communication Setting
Editor
Make the following settings on the editor. For more information, see “1.3.2 Ethernet Communication”.
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 Others
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
- When connecting to the Ethernet unit, select [Yes] for the [Batch Readout of Multiple Blocks] setting.
- When connecting to the built-in Ethernet port on the QnU series, select [Yes] for the [Random Readout] setting.
 IP address and port number of the PLC
Register on the PLC table in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
When connecting to the Ethernet unit When connecting to the built-in Ethernet port on the QnU series
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
Set the IP address, port number and
whether or not to use the KeepAlive
function of the PLC.