17.1 PLC Connection 17-7
17.1.3 X8 Series
Communication Setting
Editor
Communication setting
(Underlined setting: default)
PLC
Make communication settings using the PLC software “XGPC” (version 1.0 or greater). For more information, refer to the PLC
manual issued by the manufacturer.
Channel Configuration
Item Setting Remarks
Connection Mode
1:1
/ 1:n / Multi-link / Multi-link2 /
Multi-link2 (Ethernet) / 1:n Multi-link2 (Ethernet)
Signal Level RS-232C
/ RS-422/485
Baud Rate 4800 / 9600 / 19200 / 38400 / 57600 / 115K
bps
Data Length 8 bits
Stop Bit 1
/ 2 bits
Parity None
/ Even
Target Port No. 0 to 249
Setting Item Setting Remarks
Driver Xnet Slave
Baudrate 4.8K / 9.6K / 19.2K / 38.4K / 57.6K / 115.2K
Parity NONE / EVEN
Stop bits 1 / 2
Data bits 8
Line Control No Handshaking / No Handshaking (RS485 Network)
RS-232C connection: No Handshaking
RS-485 connection: No Handshaking (RS485
Network)
Node Address 0 to 249
To Next Page
Loading...