8-12 8. LS
8.1.8 XGT/XGK Series CPU
Communication Setting
Editor
Communication setting
(Underlined setting: default)
PLC
No particular setting is necessary on the PLC.
The following settings are fixed; baud rate: 115200 bps, data length: 8 bits, without parity, and stop bit: 1 bit.
Available Device Memory
The contents of “Available Device Memory” are the same as those described in “8.1.7 XGT/XGK Series CNET”.
8.1.9 XGT / XGK Series (Ethernet)
Communication Setting
Editor
Make the following settings on the editor. For more information, see “1.3.2 Ethernet Communication”.
IP address for the V9 unit
- When specified on the screen program:
[System Setting] [Hardware Setting] [Local Port IP Address]
- When specified on the V9 unit:
Local mode [LAN Setting]
Port number for the V9 unit (for communication with PLC)
[System Setting] [Hardware Setting] [PLC Properties] [Communication Setting]
IP address and port number (No. 2004 for TCP/IP or No. 2005 for UDP/IP) of the PLC
Register on the [PLC Table] in [System Setting] [Hardware Setting] [PLC Properties] [Target Settings].
PLC
Go to [Standard Settings] in XG-PD and set the IP address.
The port numbers are 2004 for TCP/IP and 2005 for UDP/IP (both fixed).
For more information, refer to the PLC manual issued by the manufacturer.
Calendar
Although this model is equipped with the calendar function, the V series cannot read and write to the calendar. Use the
built-in clock of the V series.
Available Device Memory
The contents of “Available Device Memory” are the same as those described in “8.1.7 XGT/XGK Series CNET”.
Item Setting Remarks
Connection Mode 1 : 1
/ Multi-link2 / Multi-link2 (Ethernet)
Signal Level RS-232C
Baud Rate 115200 bps
Data Length 8
bits
Stop Bit 1
bit
Parity None
To Next Page
Loading...