4-10 4. JTEKT
Return data: Data stored to V series from PC10G
* Writing to the FR register flash memory is performed in units of 64 KB. When writing to addresses in memory, specify an
“Ex No.” corresponding to the desired addresses for 64 KB of data.
Communication between the V series and PC10G pauses during writing.
CPU status readout
1 to 8
(PLC1 to 8)
n+4
Data 3
2
n+5
Data 4
n+6
Data 5
n+7
Data 6
n+8
Data 7
n+9
Data 8
Contents F0 F1 (=$u n) F2
15~876543210
Program and supplementary information write prohibition
Memory card operation
0 fixed
15~876543210
System memory write prohibition
System I/O read prohibition
System I/O write prohibition
System memory read prohibition
0 fixed
15~876543210
1 command step
1 block step
1 scan step
Scan sampling trace
Cyclic sampling trace
Enable detection
Trigger detection
Trace
0 fixed
15~876543210
Remote run setting
Status latch setting
I/O offline
0 fixed
15~876543210
Writing during run
Write error during run
Equipment information flash
memory writing
Program and supplementary information
write privilege restriction
Flash register write error
Flash register writing
Equipment information flash
memory write error
0 fixed
15~876543210
Program 1 running
Program 2 running
Program 3 running
0 fixed
To Next Page
Loading...