7.1 PLC Connection 7-3
DIP switch (SW5)
(Underlined setting: default)
SU-5E/6B
Universal Communication Port
System parameter setting
Set the station number, parity and data type using the system parameter setting of the programmer. For more information,
refer to the PLC manual issued by the manufacturer.
(Underlined setting: default)
The following settings are fixed; data length: 8 bits, and stop bit: 1 bit.
DIP switch
The DIP switch provided at the rear of the CPU is used to make the following settings.
(Underlined setting: default)
Host Link Module (U-01DM)
Settings are the same as those described in “SU-5” (page 7-2).
SW5 Item Setting Remarks
No. 1 P-P setting OFF
No. 2
Master/slave
setting
OFF: Slave
No. 3
Time-out
selection
OFF: Normal operation
No. 4
ASCII/HEX
selection
OFF: HEX
Item Setting Remarks
Parity Odd
/ None
Station number 1
to 90 Valid only when DIP switch No. 2 is set to OFF
Data type HEX
Switch Item Setting Remarks
No. 1 Battery mode
OFF:
Without battery
ON: With battery
No. 2
Station number
setting
OFF:
According to the system parameter setting
ON: Fixed to 01
No. 3
Baud rate
No. 4
To Next Page
Loading...