9-24 9. MITSUBISHI ELECTRIC
Open setting
Built-in Ethernet port
PC parameter
Make the settings for the IP address and the open settings in the [Built-in Ethernet port] tab window.
Item Setting Remarks
Protocol UDP
Host station Port No. (DEC)
Make settings in accordance with the
network environment.
It is not possible to set it from No. 5000 to 5002.
Transmission target device IP address (DEC) IP address of V9
Transmission target device Port No. (DEC) Port No. of V9
Item Setting Remarks
IP address (DEC)
Make settings in accordance with the
network environment.
For more information, refer to the manual of the
PLC.
Communication data code ASCII code
Enable online change
(FTP, MC protocol)
Checked
It is not possible to write value from V9 to PLC
when unchecked.
If so, “error code received 7167” occurs.
Protocol UDP
Open system MC Protocol
Host station port No. (DEC)
Make settings in accordance with the
network environment.
It is not possible to set it from No. 5000 to 5009.
To Next Page
Loading...