Fuji Electric Monitouch V9 Series - Page 241

9-48 9. MITSUBISHI ELECTRIC
Specifying the access CPU
In addition to the device type and address, an access CPU must be specified. The assigned device memory is expressed as
shown below when editing the screen.
* Q170MCPU is equipped with the sequencer CPU and motion CPU in one unit.
The multi CPU unit No. is fixed as shown below:
Management CPU: Sequencer CPU
Multi CPU 1: Sequencer CPU
Multi CPU 2: Motion CPU
Indirect Device Memory Designation
* For the SPU device memory, specify the unit number in the expansion code.
For any other devices memory, specify the access CPU number in the expansion code.
Management CPU: 0 Multi CPU: 1 or 2
Example: 1 : D00000
Address number
Device type
Access CPU No. 0: Management CPU
No. 1: Multi CPU 1
No. 2: Multi CPU 2
 For the address number of 0 to 65535:  For the address number of 65536 or greater:
15 8 7 0 15 8 7 0
n + 0 Model Device type n + 0 Model Device type
n + 1 Address No. n + 1 Lower address No.
n + 2
Expansion code
*
Bit designation n + 2 Higher address No.
n + 3 00 Station number n + 3
Expansion code
*
Bit designation
n + 4 00 Station number