9.2 Temperature Controller/Servo/Inverter Connection 9-63
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (Parameter)
Device Memory TYPE Remarks
P (parameter) 00H Refer to the list file or the parameter list for the inverter.
D (parameter) 01H Refer to the table below.
Address Name
D0 Operation mode
When issuing a command, such as a run command, from the V series, select
“Communication and Run”.
0002 H
D1 Rotation speed
D2 Output current
D3 Output voltage
D4 Alarm contents (last / most recent)
D5 Alarm contents (three times before / two times before)
D6 Alarm contents (five times before / four times before)
D7 Alarm contents (seven times before / six times before)
D8
Inverter status monitor
D9 Changeover to second parameter
D10 Special monitor
D11
Special monitor selection No.
Input terminal status
Output terminal status
Data Contents Unit Data Contents Unit
H01 Output frequency 0.01 Hz H10 Output terminal status -
H02 Output current 0.01 A H11 Load meter 0.1%
H03 Output voltage 0.1V H12 Motor exciting current 0.01A
H05 Speed setting 1 r/min H13 Position pulse -
H06 Operation speed 1 r/min H14 Total power-on time 1h
H07 Motor torque 0.1% H17 Operating time 1h
H08 Converter output 0.1 V H18 Motor load ratio 0.1%
H09 Regenerative brake 0.1% H20 Torque command 0.1%
H0A Electric thermal load ratio 0.1% H21
Torque curren t
command
0.1%
H0B Output current peak value 0.01 A H22 Motor output 0.01 kW
H0C
Output voltage peak value
of converter
0.1 V H23 Feed back pulse -
H0F Input terminal status -
Bit 15 - 8 RES CH DI4 DI3 DI2 DI1 STR STF
Bit 15 - 4 ABC D03 D02 D01
To Next Page
Loading...