Fuji Electric Monitouch V9 Series - Page 268

9.2 Temperature Controller/Servo/Inverter Connection 9-75
Return data: Data stored from controller to V series
*1 When executing this command, the setting values of communication parameter for V9 series are also returned to the initial values. Set the
parameter again.
*2 The description changes depending on the setting of Pr.180 to 184.
Write run command
(Expansion)
1 - 8
(PLC1 - 8)
n
Station number
3
n+1
Command: 00F9H
n + 2
0000H: stop
Write run command
1 - 8
(PLC1 - 8)
n
Station number
3
n + 1
Command: 00FAH
n + 2
0000H: stop
All alarms clear
1 - 8
(PLC1 - 8)
n
Station number
2
n + 1
Command: 00F4H
Contents F0 F1 (= $u n) F2
bit
-11-76543210
AU (current input selection)
Forward rotation command
Reverse rotation command
RES (reset)
RT (second function selection)
RH (high speed operation command)
*2
RM (middle speed operation command)
*2
RL (low speed operation command)
*2
MRS (output stop)
*2
Not usedNot used
bit
15- 876543210
AU (current input selection)
Forward rotation command
Reverse rotation command
RT (second function selection)
RH (high speed operation command)
*2
RM (middle speed operation command)
*2
RL (low speed operation command)
*2
MRS (output stop)
*2
Not used