13.1 PLC Connection 13-17
PLC
Communication setting
The communication setting is the same as the one described in “13.1.3 SYSMAC CS1/CJ1”.
CX-Integrator
Set the PLC routing table on “CX-Integrator”. Two types of routing tables are available: local network table and relay network
table.
An error will occur unless these settings are made correctly. For more information, refer to the PLC manual issued by the
manufacturer.
Local network table
Set the unit number and network number of the communication unit.
Relay network table
Set the network number of the access target (final network No.) and the first relay point (relay network No., relay node
No.).
Rotary switch
Available Device Memory
The available device memory is the same as the one described in “13.1.3 SYSMAC CS1/CJ1”.
Switch Setting
NODE No. Set the node number of the Controller Link unit.
To Next Page
Loading...