Fuji Electric Monitouch V9 Series - Page 309

13-22 13. OMRON
13.1.7 SYSMAC CS1/CJ1 DNA (Ethernet)
The V9 series can communicate with CS1/CJ1 on the network (Controller Link) via the Ethernet unit.
Communication Setting
Editor
Make the following settings on the editor. For more information, see “1.3.2 Ethernet Communication”.
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number (for communication with PLC) and local port number (V9 DNA table number) of the V9 unit
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
F 1
F 2
F 3
F 4
F 5
F 6
F 7
SYSTEM
V9
No. IP address
0
1 192.168.1.1
2 192.168.1.2
:
192.168.1.1
192.168.1.2
192.168.1.10
No.
0 1 2 2
1 1 3 2
2 2 2 2
:
10 5 10 0
CJ1
CJ1CJ1
CLK
CLK CLK CLK
ETNCJ1 ETN
CJ1 CLK
Ethernet
Node
2
Node
2
Node
1
Node
2
Network No. 1 Network No. 2
PLC table
DNA table
Network No. 5
Node
1
Node
1
Node 10
Relay targetNetwork Node
The V9 series accesses to a PLC on the network number 1 or 2 via PLC table number
2 (192.168.1.2). In this case, specify “2” for the relay target.
Set the network number and node number of the V9 to the
same DNA table number as the V9 node number.
Node
3
Set the same number as the one
specified for [FINS/UDP Port] on
the PLC.
Set the DNA table number of the V9.