13.2 Temperature Controller/Servo/Inverter Connection 13-43
13.2.9 E5ZD
Communication Setting
Editor
Communication setting
(Underlined setting: default)
Temperature Controller
(Underlined setting: default)
The following settings are fixed; data length: 7, stop bit: 2, and parity: even.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Item Setting Remarks
Connection Mode
1:1 / 1:n
/ Multi-link2 / Multi-link2 (Ethernet) /
1:n Multi-link2 (Ethernet)
Signal Level RS-232C / RS-422/485
Baud Rate 4800 / 9600 bps
Data Length 7 bits
Stop Bit 2 bits
Parity Even
Targe t Port No. 0
to 15
Switch Setting Data Setting
SW2 Unit No. 0
to F (= 0 to 15)
SW3 Baud rate
5: 4800 bps
6: 9600 bps
Device Memory TYPE Remarks
-
0000 Control temperature
00H
0001 Measurement temperature Bank No. 0
0002 Operation status Bank No. 0
0003 Output value Bank No. 0
0004 Output value on the cooling side Bank No. 0
0005 Proportional band
0006 Integral time
0007 Derivative time
0008 Control cycle
0009 Control cycle on the cooling side
000A Output operation Bank No. 0
000B Heater disconnection effective channel Bank No. 0
000C Alarm status Bank No. 0
000D Warning mode: warning 1 Bank No. 0
000E Warning mode: warning 2 Bank No. 0
000F Temperature at which an alarm occurs:
warning 1
0010 Temperature at which an alarm occurs:
warning 2
0011 Execution memory bank No. Bank No. 0
0012 Adjustment sensitivity
0013 Adjustment sensitivity on the cooling side
0015 Input offset value
001D Heater disconnection detection level
001F Heater current value Bank No. 0
0021 Deadband / overlap band Bank No. 0
0022 Cooling coefficient
To Next Page
Loading...