15.1 PLC Connection 15-11
IP address and port number of the PLC
Register on the [PLC Table] in [System Setting] [Hardware Setting] [PLC Properties] [Target Settings].
Set the same PLC table number as the one set for “MEWTOCOL Station Number” ([Initial Information Setting] [Local
Node Setting]).
PLC
Make the mode setting using the Ethernet unit “FP2-ET1”.
Mode setting switch
Make the PLC setting using the configuration tool “Configurator ET”. For more information, refer to the PLC manual issued by
the manufacturer.
Initial information setting
Connection setting
Match the number to the
MEWTOCOL station
number of the PLC.
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
Set the IP address, port number and
whether or not to use the KeepAlive
function of the PLC.
Switch Setting Contents Remarks
2 ON Auto connection function
Item Setting
Local Node Setting
IP Address IP address of the PLC
MEWTOCOL Station Number
1 to 31
* The same number must be specified for the PLC table number of the V9.
Item Setting
Connection
1 to 8
* Select a port to
which the V9 is
connected.
Communication Mode UDP/IP
Open Type Unpassive
Usage MEWTOCOL communication
Local Node (PLC) Port Number As desired
Target Node IP Address IP address of the V9
Target Node Port Number Port number of the V9
Target Node MEWTOCOL Station
Number
1 to 31
* Match the number to the one set for [Local Port No.] under [Communication
Setting] on the V9.
Connection Setting Valid
To Next Page
Loading...